Overdrive, Amp models, and Mic models (OD Amp Mic)
457
024: St. Tube PreAmp
(Stereo Tube PreAmp Modeling)
This is a stereo vacuum tube preamp simulator (see p.456,
023: Tube PreAmp Model (Tube PreAmp Modeling)).
025: Mic Model+PreAmp
(Mic Modeling + PreAmp)
This effect simulates a mic and vacuum tube preamp. You
can choose from various types of mic and positions to create
differing sonic characters.
b: Mic Position
This expresses the effect that the mic position has on the
sound. The Close setting is the closest mic position, and the
Far setting is the farthest.
aMic Type
Vintage
Dynamic,
Multi
Condenser,
Percussion
Condenser,
Drums Dynamic,
Vocal Dynamic,
Multi Dynamic,
Vocal
Condenser,
Vocal Tube,
Kick Dynamic
Selects the type of mic
bMic Position
Close, On,
Off, Far
Sets the mic placement
distance p.457
c
Tube Low
Cut [Hz]
Thru,
21...8.00k
Sets the frequency of the low
cut filter
High Cut [Hz]
53...20.00k,
Thru
Sets the frequency of the high
cut filter
d
Tube Gain
[dB]
–24.0...+24.0
Sets the input gain to the
vacuum tube preamp
Saturation
[%]
0...100
Sets the input/output response
of the preamp p.456
eTube Bias 0...100
Sets the bias level of the
preamp p.456
f
Tube Output
Level [dB]
–48.0...+0.0
Sets the output level of the
preamp
g
Wet/Dry
Dry, 1 : 99...
99 : 1, Wet
Sets the balance between the
effect and the dry input
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount
for Wet/Dry
Left
Right
Wet / Dry
Output Level
Wet / Dry
Stereo In - Stereo Out
Tube Pre Amp1 Tube Pre Amp2
Tube Pre Amp1 Tube Pre Amp2
Left
Right
Wet / Dry
Wet / Dry
–
+
–
+
Invert
+
Tube Pre AmpMic Simulation
Left
Right
Wet / Dry
Output Level
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
To Next Page
Loading...
Need help?
General
