Global P3: Scales 3–1: Scales
373
Global P3: Scales
3–1: Scales
Here you can make settings for sixteen different User Octave
Scales and one User All Notes scale.
The user scales you create here can be selected from the
following pages.
• Prog P1: Basic/DT/Ctrls– Key Zone/Scale
• Combi P3: Timbre Param– Other T01–08/T09–16
• Seq P3: Track Param– Other T01–08/T09–16
Note: For the optional EXB-RADIAS, use Prog P1: Basic/
DT/Ctrls– Program Basic to select the scale.
If you wish to keep an edited user scale after the power
is turned off, be sure to write (save) your settings.
Use the menu command Write Global Setting or press
the SEQUENCER REC/WRITE switch to open the
dialog box, and write the data.
3–1a: User Octave Scale
User Octave Scale [User Octave Scale 00...15]
Selects the User Octave Scale that you want to edit.
Tune [–99…+99]
Makes pitch settings for each note in the octave.
When you adjust the pitch of each note in the octave (C–B)
in one-cent steps, your settings will be applied to all octaves.
This adjustment is relative to equal temperament.
A setting of –99 lowers the pitch approximately a semitone
below normal pitch.
A setting of +99 raises the pitch approximately a semitone
above normal pitch.
The note can also be selected by holding down the ENTER
switch and playing a note on the keyboard.
By executing the menu command Copy Scale, you can copy
settings from a preset scale (other than Stretch) or from
another user scale.
3–1b: User All Notes Scale
Tune [–99…+99]
Makes independent pitch settings for each of the 128 notes.
Adjust the pitch of each of the 128 notes (C–1 – G9) in one-
cent steps. This adjustment is relative to equal temperament.
A setting of –99 lowers the pitch approximately a semitone
below normal pitch.
A setting of +99 raises the pitch approximately a semitone
above normal pitch.
Use the horizontal scroll bar to move to the key range that
you want to set, and select the key that you want to specify.
The note can also be selected by holding down the ENTER
switch and playing a note on the keyboard.
By executing the menu command Copy Scale, you can copy
settings from a preset scale (including Stretch) or another
user scale.
▼3–1: Menu Command
• 0: Write Global Setting ☞p.382
• 1: Copy Scale ☞p.387
For more information, please see “Global: Menu Command”
on page 382.
3–1a
3–1b
3–1
Menu
To Next Page
Loading...
Need help?
General
