COMBI P1: DT/XY/Ctrls 1–2: X–Y Vol T01–08, 1–3: X–Y Vol T09–16
139
▼1–1: Menu Command
• 0: Write Combination ☞p.185
• 1: Panel–SW Solo Mode On ☞p.106
• 2: Exclusive Solo ☞p.107
• 3: Copy from Program ☞p.185
• 4: Copy Drum Track ☞p.112
• 5: Erase Drum Track Pattern ☞p.112
For more information, please see “Combination: Menu
Command” on page 185.
1–2: X–Y Vol T01–08,
1–3: X–Y Vol T09–16
(X–Y Volume Control T01–08, T09–16)
X–Y Control lets you control the timbre volume and
program or effect parameters by moving your finger on the
display (X–Y Mode) or by using an X–Y Motion that records
such a movement.
For more background information on X–Y control, please
see “1–5: X–Y Setup” on page 31.
X–Y control operation of programs and combina-
tions
Volume and CC control of each timbre program in
Combination mode can be performed according to the X–Y
control settings made in Program mode. You can disable the
Program X–Y Volume and CC control separately for each
timbre, if desired.
There is also a separate Combi-wide X–Y control, with its
own X–Y Volume and X–Y CC control settings. As with the
Program X–Y control, you can disable the Combi Volume
and CC control separately for each timbre.
How Combi X–Y Volume works
In Program mode, X–Y Volume fades between the two
Oscillators. Oscillator 1 is always at maximum volume when
the X–Y position is all the way to the left (–X), and Oscillator
2 is always at maximum when the X–Y Position is all the
way to the right (+X).
In Combination mode, on the other hand, the X–Y Volume
can fade between any or all of the 16 Timbres. You can
assign each of the Timbres to be controlled by any of the four
X–Y axes (+X, –X, +Y, –Y), or to not be controlled at all.
If the EXB-RADIAS is installed, you can create complex
fades between different programs, such as EDS programs
and RADIAS programs.
1–2(3)a: X–Y Volume Control
X–Y Volume Control lets you adjust the relative volumes of
the 16 Timbres by moving the X–Y mode (or the X–Y
motion) from left to right on the X axis, and up and down on
the Y axis.
The Equal Amount check-box makes the X–Y control create
a smooth fade between the Timbres, while the individual
Center Volume parameters allow you to create more
complex fade shapes.
Enable Volume Control [Off, On]
On (checked): X–Y position movements will control the
volume of all timbres whose X–Y Assign is not Off.
1–2a
1–2c
1–2d
1–2
Menu
1–2b
To Next Page
Loading...
Need help?
General
