Global mode
366
1–2: MIDI Routing
Here you can make MIDI routing and filtering settings for
the entire M3.
Note: To transmit MIDI exclusive dump data, you’ll use the
menu commands of this P1: MIDI page.
1–2a: MIDI Routing
X–Y MIDI Out [X–Y, X–Y CC Control]
These settings specify how MIDI output will occur when
you move your finger over the display when X–Y Mode is
on, or use the X–Y Motion function to capture such a
movement.
X–Y: X–Y Mode or X–Y Motion will transmit the two MIDI
control change messages assigned by X (X–Y Mode) and Y
(X–Y Mode) (Global 2–2b). With the default settings, X (X–Y
Mode) is CC#118, and Y (X–Y Mode) is CC#119. Normally
you will set this to X–Y. Choose this setting if you want to
use movements of X–Y Mode or X–Y Motion to control an
external MIDI device or record these movements into the
internal sequencer or an external sequencer.
X–Y CC Control: The M3 will transmit the MIDI control
change messages specified by the X–Y CC Control “+X,”
“–X,” “+Y,” and “–Y” settings in each program,
combination, or song. Movements of X–Y Mode or X–Y
Motion will transmit MIDI control change messages.
Normally you will use this to control the internal tone
generator or effects, but you can also use it to transmit
messages to an external MIDI device, or to record these
movements on the internal sequencer or an external
sequencer.
Pads MIDI Out [Pad CC/Note, Chord Notes]
This setting specifies the MIDI messages that are output
when you strike a pad.
Pad CC/Note: When you strike a pad, the MIDI note
number or MIDI control change message specified by the
Pad Pad1–Pad8 (Global 2–2c) setting will be transmitted.
If the setting is off, no MIDI message will be transmitted.
Chord Notes: When you strike a pad, the (up to eight) MIDI
note-on/off messages (and velocities) specified by the Pad
Pad1–Pad8 (Global 1–4b) setting of each program,
combination, or song will be transmitted. If all notes are
turned off, no MIDI messages will be transmitted.
KARMA External:
Enable KARMA Module to MIDI Out [Off, On]
This setting specifies whether the KARMA Module will
transmit MIDI messages.
On (checked): The KARMA Module will transmit MIDI
messages.
Off (unchecked): The KARMA Module will not transmit
MIDI messages. MIDI events generated by the KARMA
Module will sound the internal tone generator, but MIDI
messages will not be output.
Enable MIDI In to KARMA Module [Off, On]
This setting specifies whether MIDI messages from the MIDI
IN connector will be sent to the KARMA Module.
On (checked): MIDI messages will be sent to the KARMA
Module.
Off (unchecked): MIDI messages will not be sent to the
KARMA Module.
1–2a
1–2b
1–2
Menu
X–Y CC Control
X–Y Volume Control
X–Y CC MIDI Output
Program switch:
“Enable CC control”
Program switch:
“Enable Volume control”
Global switch (P1: MIDI):
“X–Y MIDI Out”
X–Y CC MIDI Output
X–Y
MODE
X–Y CC Control
X–Y MODE
MIDI In
X–Y Mortion
scale
Global Controllers
MIDI CC Assignments
Defaults: X=118, Y=119
X and Y modes
Osc 1/2 Center Volume
and Equal Power settings
X+/– and Y+/–
CC Assignments
X–Y
CC Modulation of
Program and FX Parameters
X–Y Modulation of
Oscillator Volume
To Next Page
Loading...
Need help?
General
