Global P1: MIDI 1–1: MIDI Basic
365
This parameter cannot be set if MIDI Clock is Internal.
SEQ Mode:
Track MIDI Out
[for Master, for External Sequencer]
This setting specifies what will be transmitted via MIDI
when you switch songs in Sequencer mode.
for Master: When you switch songs in Sequencer mode,
tracks whose Status is EXT or BTH will transmit MIDI
messages* such as program changes to set-up an external
MIDI sound module.
for External Sequencer: You should choose this if you’re
using Sequencer mode as an external multi-timbral sound
module. When you switch songs on the M3, no track whose
Status is set to EXT or BTH (i.e., any setting other than INT)
will transmit MIDI messages* such as program changes.
This prevents echo-back from the tracks of your external
MIDI sequencer from overwriting the program and other
parameters of tracks that are set to the same MIDI channel.
* Applicable parameters
• Program Select: CC#00 bank select (LSB), CC#32 bank
select (MSB), program change
• Pan: CC#10 pan
• Volume: CC#7 volume
• Portamento: CC#65 portamento On/Off, CC#5
portamento time
• Send 1/2: CC#93 send 1 level, CC#91 send 2 level
• (Post FX) Pan: CC#8 post insert effect pan
Param. MIDI Out
[Control Change, SysEx-param Change]
This setting specifies whether control changes or system
exclusive messages will be transmitted when you edit a
parameter in Sequencer mode.
Control Change: Data for the edited parameter will be
transmitted as a control change.
SysEx-param Change: Data for the edited parameter will be
transmitted as a parameter change.
Note: For these to operate, Enable Control Change or
Enable Exclusive (Global P1: MIDI– MIDI Routing) must be
checked respectively.
* Applicable parameters
• Pan: CC#10 pan
• Volume: CC#7 volume
• Send 1/2: CC#93 send 1 level, CC#91 send 2 level
Drum Track:
Drum track programs in Program mode will be triggered on
the global MIDI channel if Trigger Mode is set to Wait KBD
Trig. The MIDI transmit channel is specified by the Drum
Track Prog MIDI Ch. Use the Drum Track Prog MIDI Out
to specify whether the MIDI note data of the pattern will be
transmitted.
Drum track programs do not transmit or receive MIDI
program changes.
Prog MIDI Ch [01…16]
This specifies the MIDI channel for drum track transmission
and reception in Program mode. If Prog MIDI Out is
checked, drum pattern note data will be transmitted on this
MIDI channel. The default setting is channel 10.
Prog MIDI Out [Off, On]
On (checked): The note data of the drum track pattern will
be transmitted on the channel specified by Prog MIDI Ch.
Off (unchecked): The note data of the drum track pattern
will not be transmitted.
▼1–1: Menu Command
• 0: Write Global Setting ☞p.382
• 1: Dump Program ☞p.384
• 2: Dump Combination ☞p.384
• 3: Dump Drum Kit ☞p.384
• 4: Dump Global Setting ☞p.384
• 5: Dump Sequencer ☞p.384
• 6: Dump Drum Track Pattern ☞p.384
• 7: Dump Formant Motion ☞p.384
• 8: Setup KARMA Ext. MIDI (Setup KARMA External
MIDI Routing) ☞p.386
For more information, please see “Global: Menu Command”
on page 382.
To Next Page
Loading...
Need help?
General
