Sequencer mode
212
CC# Assign [Off, 000…119]
This read-only parameter shows the MIDI CC sent by the
slider.
Value [000…127]
This is the current value of the slider’s MIDI CC.
Tone Adjust
Tone Adjust provides two important features
simultaneously:
• The Tone Adjust parameter lets you use the sliders and
switches to control the principal Program parameters as
if you were turning the knobs of an analog synthesizer.
• It lets you modify Programs for use within a specific
Song, including everything from subtle tweaks (like
changing LFO speeds) to dramatic changes (such as
selecting a different Multisample). Any changes that you
make are stored with the Song, and do not alter the
original Program.
Each of the sixteen tracks has its own set of tone adjust
parameters. However, only one track at a track can be
adjusted from the control surface.
For more information, see:
•“Tone Adjust and MIDI SysEx” on page 20
•“Interaction between Tone Adjust and MIDI CCs” on
page 20
•“Absolute (Abs), Relative (Rel), Meta parameter” on
page 19
Saving Tone Adjust Edits
In Program mode, when you make edits via Tone Adjust
and then save the results, the Program data is changed–just
as if you’d edited the internal parameters directly. For more
information, please see “Saving Tone Adjust Edits” on
page 20.
In Sequencer mode, however, all Tone Adjust edits are
stored within the Song; the Program itself is not changed.
This lets you alter the way that a Program sounds in one
specific Song without affecting the way that it sounds in
Program mode, or in any other Combis or Songs.
0–2–8g: Tone Adjust
Track select
Track [1…16]
This selects the track whose Tone Adjust parameters. You
can switch back and forth between the different tracks as
much as you like, without losing your edits.
Auto Load (Auto Load PRG) [Off, On]
When you first load a Program into a track, this parameter
determines whether or not the Program’s Tone Adjust
settings will be loaded as well.
These settings include the parameters assigned to each
slider, and switch, along with the on/off state of any
Switches assigned to Absolute parameters.
Once the Program has been loaded, you can change any or
all of the Tone Adjust settings as desired, including both
0–2
–8b
0–2
–8a
0–2
–8g
0–2
–8
Menu
To Next Page
Loading...
Need help?
General
