PROG P1: Basic/DT/Ctrls (Basic/Drum Track/Controllers) 1–6: Controllers Setup
35
1–6: Controllers Setup
Here you can specify the SW1 and SW2 switch and 5–8
slider functions of the program when Control Assign
REALTIME CONTROL is selected.
Note: SW1 and SW2 can be controlled by the KYBD-61/73/
88’s SW1 and SW2 switches.
1–6a: Panel Switch Assign
SW (SW1 Assign) [Off, ..., After Touch Lock]
This assigns the function of SW1. For more information,
please see “List of SW 1/2 assignments” on page 597.
Note: If the KYBD-61/73/88 is connected, the on/off status
of the SW1, SW2 switches is memorized when you save the
program.
If you change the function setting, the status is reset to off.
Mode (SW1 Mode) [Toggle, Momentary]
This specifies the on/off operation when you press the SW1
switch.
Toggle: The state will alternate between On and Off each
time you press the SW1 switch.
Momentary: The state will remain On only while you
continue holding down the SW1 switch.
SW2 Assign [Off, ..., After Touch Lock]
SW2 Mode [Toggle, Momentary]
This assigns the function of SW2. The functions that can be
assigned to SW2 are the same as for SW1, with the
substitution of SW2 Mod. (CC#81) instead of the SW1’s SW1
Mod. (CC#80).
1–6b:Realtime Control Slider Assign
Here you can assign the functions (mainly types of control
change) that sliders 5–8 will have when Control Assign
REALTIME CONTROL is selected. (See “Realtime Control
Slider 5–8 Assignments” on page 598)
The functions you assign here are active when you select
CONTROL ASSIGN REALTIME CONTROL switch and
operate sliders 5–8.
Slider 5 [Off, ..., MIDI CC#95]
Slider 6 [Off, ..., MIDI CC#95]
Slider 7 [Off, ..., MIDI CC#95]
Slider 8 [Off, ..., MIDI CC#95]
▼1–6: Menu Command
• 0: Write Program ☞p.106
• 1: Panel–SW Solo Mode On ☞p.106
• 2: Exclusive Solo ☞p.107
For more information, please see “Program: Menu
Command” on page 106.
1–6a
1–6b
1–6
Menu
To Next Page
Loading...
Need help?
General
