System Exclusive events supported in Sequencer mode Copy Song
295
System Exclusive events supported in Sequencer mode
You can record and play back System Exclusive events, and edit tracks that contain System Exclusive events.
SysEx messages that can be recorded in real-time
The following exclusive messages can be recorded in real-time:
• Exclusive messages received from an external MIDI device
• Parameter changes in Sequencer mode (see table below)
• Master Volume universal exclusive messages assigned to the foot pedal or a slider
Parameter change messages that you can realtime-record in Sequencer mode
*1: Solo On/Off is always controlled by events in the track,
regardless of the play/mute status of that track.
The maximum amount of exclusive data that can be
recorded at once is approximately 320 Kbytes. This size
will decrease if other events exist within the same
measure.
You cannot simultaneously record exclusive messages
received from an external MIDI device and parameter
changes produced by editing.
The events that will be recorded are controlled by the
Global P1: MIDI– MIDI Basic settings SEQ Mode
Param. MIDI Out. For Control Change, only control
change messages will be recorded. For SysEX-Param
Change, only parameter changes and exclusive
messages will be recorded.
Front panel/Page Parameter
Front panel
KARMA ON/OFF, LATCH, MODULE CONTROL switches
Control Surface CONTROL ASSIGN, PAD MODE switches
P0: Play/REC
Program, Mixer Program Select, Pan, Volume, PLAY/MUTE, Solo On/Off
*1
Sampling/Audio In All “Audio Input” parameters
Control Surface
All “MIXER,” “RT CONTROL,” “KARMA SCENE,” “KARMA Switch,” “KARMA Slider” parameters, “TONE ADJ.”
– Assign, Value
P1: DT/XY/Ctrls
X–Y Vol All “X–Y Volume Control” parameters, X–Y Assign, Center Volume, Enable Program X–Y Volume
X–Y CC All “X–Y CC Control” parameters, Enable Seq X–Y CC, Enable Program X–Y CC
Controllers Setup All “Panel Switch Assign,” “Realtime Control Slider Assign” parameters
Pads Setup All “Pads Chord” parameters
P2: EQ/Option EQ Trim Auto Load Prog EQ, Bypass, Input Trim, High Gain, Mid Frequency, Mid Gain, Low Gain
P3: Track Param
MIDI
OSC Force OSC Mode, OSC Select, Portamento
Pitch Transpose, Detune, Bend Range, Other
P4: Zone/Delay Delay Mode, Time, Base Note, Times
P7: KARMA
GE Setup Load GEOptions
Note Map All parameters except “Octave Replicate”
P8: IFX
Routing1/2 Bus Select, Send1, Send2, Fx Control Bus, AUX Bus
Insert FX IFX, IFX On/Off, Chain to, Chain, Pan, Bus Sel, AUX Bus, Ctrl Bus, Send1, Send2
IFX 1–5 All effect parameters
Common FX LFO All “Common FX LFO 1, 2” parameters
P9: MFX/TFX
Routing
MFX, MFX On/Off, Chain, Chain Direction, Chain Level, Return 1, Return 2, TFX, TFX On/Off, Master
Volume
MFX 1/2 All effect parameters
TFX All effect parameters
To Next Page
Loading...
Need help?
General
