Delay
481
c: Envelope Select
c: Src
d: Threshold
These parameters select the source to control the start and
end of recording.
When Envelope Select is set to D-mod, the input signal will
be recorded only when the value of the modulation source
selected by the Src parameter is 64 or higher.
When Envelope Select is set to Input, the input signal will
be recorded only when its level exceeds the Threshold level.
When recording is completed, reverse playback starts
immediately.
063: Sequence BPM Dly
(Sequence BPM Delay)
This four-tap delay enables you to select a tempo and
rhythm pattern to set up each tap.
a: BPM
b: Rhythm Pattern
With the tempo specified by the BPM parameter (or the
MIDI Clock tempo if BPM is set to MIDI), the length of one
beat equals the feedback delay time, and the interval
between taps becomes equal. Selecting a rhythm pattern will
automatically turn the tap outputs on and off. When BPM is
set to MIDI, the lower limit of the BPM is 44.
RecRec
Mode/Reverse Time
Input
Mode = Single
Mode = Multi
Time
Reverse Time Reverse Time
Envelope Select = Input
Reverse Reverse
a BPM
MIDI,
40.00...
300.00
MIDI syncs to the system
tempo; 40–300 sets the tempo
manually for this individual
effect p.481
b
Rhythm
Pattern
...
3
Selects a rhythm pattern
p.481
c
Tap1 Pan L, 1...99, R Sets the panning of Tap1
Tap2 Pan L, 1...99, R Sets the panning of Tap2
Tap3 Pan L, 1...99, R Sets the panning of Tap3
Tap4 Pan L, 1...99, R Sets the panning of Tap4
d
Feedback –100...+100 Sets the feedback amount
Src Off...Tempo
Selects the modulation source
of feedback amount
Amt –100...+100 Sets the feedback amount
e
High Damp
[%]
0...100
Sets the damping amount in
the high range p.476
Low Damp
[%]
0...100
Sets the damping amount in
the low range p.476
f
Input Level
Dmod [%]
–100...+100
Sets the modulation amount of
the input level p.472
Src Off...Tempo
Selects the modulation source
for the input level p.472
g
Wet/Dry
Dry, 1 : 99...
99 : 1, Wet
Sets the balance between the
effect and the dry input
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount
for Wet/Dry
Delay
Left
Right
Feedback
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Input Level D-mod
High Damp Low Damp
Input Level D-mod
+
Tempo
BPM
BPM
Rythm Pattern
Pan
To Next Page
Loading...
Need help?
General
