Combination mode
180
For instance, you can save an Effect Preset while working on
a particular Combination, and then later use the same Effect
Preset in a different Program, Combination, or Song.
P00: Initial Set: These are the default settings that are
recalled when you select an effect type in the Insert FX Setup
page. You can’t save your own settings here.
P01…P15: These contain preset data that Korg plans to
provide in the future. We recommend that you store your
settings in U00–U15.
U00…U15: These are areas in which you can store your own
settings.
---------------: This shows that no Effect Preset has been
selected. You’ll see this if you’ve just selected an effect,
written a program, or selected a new Combination. Selecting
this setting from the menu will not have any effect.
Note: Combis save the effects parameter settings, but they
don’t save the number of the selected Effect Preset. If you
select an Effect Preset, and then save the Combination, the
Effect Preset setting will revert to “--------------.”
For more information, please see “Using Effect Presets” on
page 101.
IFX1 Parameters:
IFX1 Parameters
Here you can set the effect parameters of the insert effect
you chose in the Insert FX Setup page.
For more details, please see “Insert Effects (IFX1…IFX5)” on
page 426.
▼8–1–4: Menu Command
• 0: Write Combination ☞p.185
• 1: Panel–SW Solo Mode On ☞p.106
• 2: Exclusive Solo ☞p.107
• 3: Copy Insert Effect ☞p.117
• 4: Swap Insert Effect ☞p.118
• 5: Write FX Preset ☞p.190
For more information, please see “Combination: Menu
Command” on page 185.
8–1–5: IFX2,
8–1–6: IFX3,
8–1–7: IFX4,
8–1–8: IFX5
Here you can edit the effect parameters for insert effects 2–5
selected in the Insert FX Setup page.
For more information, please see “8–1–4: IFX1,” above.
To Next Page
Loading...
Need help?
General
