Combination mode
190
DrumKit IFX Patch
This patches the Bus Select settings for each key of a drum
kit, temporarily changing the insert effect connection
destinations.
You can execute this command if the program assigned to
the timbre is a drum program and Bus Select is set to DKit.
The Bus Select setting (Global 5–4b) of each key in the drum
kit must be set to one of IFX1–5.
1. In the Routing1 page or Routing2 page, select the tim-
bre for which you want to make settings. (Select a tim-
bre parameter or Timbre Number.)
2. Select “DrumKit IFX Patch” to open the dialog box.
3. In the DrumKit “IFX” popup, select the output bus to
which you want to patch the signal: an insert effect or
L/R, 1–4, 1/2, 3/4, or Off.
4. To execute the Drum Kit Insert Effect Patch command,
press the OK button. To cancel, press the Cancel button.
Note: To restore the condition of the drum kit, execute
IFX1→IFX1, IFX2→IFX2, IFX3→IFX3, IFX4→IFX4,
IFX5→IFX5 (see page 177).
Copy MFX/TFX
This command copies effect settings from Program,
Combination, Song, or Sampling modes. For more
information, please see “Copy MFX/TFX” on page 118.
Note: The slot’s MIDI control channel, as specified by the Ch
parameter on the P9: MFX/TFX– MFX1 and TFX page, will
not be copied.
Swap MFX/TFX
This command swaps (exchanges) insert effect settings. For
more information, please see “Swap MFX/TFX” on
page 118.
Note: The slot’s MIDI control channel, as specified by the Ch
parameter on the P9: MFX/TFX– MFX1 and TFX page, will
not be copied.
Write FX Preset
This command saves the edited effect into the M3’s internal
memory.
For more information, please see “Write FX Preset” on
page 118.
To Next Page
Loading...
Need help?
General
