Sequencer: Menu Command GM Initialize
273
GM Initialize
This command transmits a GM System On message to the
Sequencer mode, resetting all tracks to the GM settings. For
more information, please see “GM Initialize List” on
page 274.
1. Select “GM Initialize” to open the dialog box.
2. To execute the settings, press the OK button. To cancel,
press the Cancel button.
In Sequencer mode, when a GM System On message is
received from an external device, or if a GM System On
message is recorded in the sequence data, the M3 will
be reset to settings appropriate for GM just as if you
had executed this command. However, in these cases,
the various P9: Master/Total Effect parameters will not
be reset.
Copy From Combi (Copy from
Combination)
This command copies the parameters of the specified
combination to the setting data of the currently selected
song.
Note: Only the timbres used by the combination will be
copied. Timbres in the combination whose Status is Off will
not be copied. If any timbres are set to Mute, the
corresponding tracks of the song will be set to a Status of
Off.
1. Select “Copy From Combi” to open the dialog box.
2. In Combination, select the copy source destination.
3. Use the IFXs, MFXs and TFX check boxes to specify
whether you want the effect settings of the combina-
tion to be copied as well.
IFXs: All insert effect settings of the copy-source
combination (the contents of the IFX page and the IFX1–5
effect parameters) will be copied.
MFXs: All master effect settings of the copy-source
combination will be copied.
TFX: All total effect settings of the copy-source combination
will be copied.
4. Specify the desired Multi REC Standby setting.
On: The Status will automatically be set to REC for MIDI
tracks corresponding to valid timbres in the copy-source
combination. In addition, Multi REC (Seq 0–1–8b) will
automatically be turned on, and Recording Setup (Seq 0–1–
8b) will be set to Overwrite.
5. To execute the Copy operation, press the OK button. To
cancel, press the Cancel button.
Copy from Program
This command copies settings from the program you specify
to the currently selected song.
This is the same function as in Combination mode; for
details, please see “Copy from Program” on page 185.
This command in Sequencer mode differs from its behavior
in Combination mode in that the channels assigned to the
tracks of the song will be preserved regardless of the with
KARMA setting of the copy-destination track’s MIDI
Channel. (See step 4.)
To Next Page
Loading...
Need help?
General
