Combination mode
168
For more information, please see “How the Start Seed
setting affects the phrase” on page 82.
Freeze Loop Length [Off, 01…32]
Specifies the number of measures in the phrases that are
repeatedly generated by the KARMA module. After being
triggered, the module will generate a phrase of the number
of measures you specify here, and will then repeat that
phrase.
If you set this to Off, the phrase will not be repeated.
For more information, please see “Examples of Start Seed
and Freeze Loop Length settings” on page 83.
Retrigger Each Time [Off, On]
On (checked): Every time the measures specified by Freeze
Loop Length are repeated, the Phase Pattern, Envelope, and
Index Pattern will retrigger as if the keyboard itself etc. was
retriggered.
The phrase will be restarted according to the Note Trigger
setting (see “Note Trigger” on page 93) and GE settings, and
the envelope will be retriggered according to the Envelope
Trigger/Latch settings. For more information, please see
“Envelope Trigger” on page 89, “Envelope Latch” on
page 89 and “Checking the Freeze Randomize function, and
performing “Capture Random Seed”” on page 116.
Off (unchecked): The Phase Pattern, Envelope, and Index
Pattern will be retriggered according to the length of the
phase pattern specified by the GE. For example in a GE for
which an eight-measure phase pattern is specified, and
Freeze Loop Length is set to two measures, the
randomizations of the rhythm and phrase etc. will be reset
every two measures. Then the phrase and envelope will be
retriggered every eight measures. For more information,
please see “Checking the Freeze Randomize function, and
performing “Capture Random Seed”” on page 116.
Note: Retrigger Each Time is not available if Freeze Loop
Length is off.
Note: For some GE settings, on and off may produce the
same result.
▼7–1–8: Menu Command
• 0: Write Combination ☞p.185
• 1: Panel–SW Solo Mode On ☞p.106
• 2: Exclusive Solo ☞p.107
• 3: Copy KARMA Module ☞p.114
• 4: Initialize KARMA Module ☞p.115
• 5: Copy Scene ☞p.115
• 6: Swap Scene ☞p.115
• 7: Capture Random Seed ☞p.116
• 8: Copy from Program ☞p.185
For more information, please see “Combination: Menu
Command” on page 185.
To Next Page
Loading...
Need help?
General
