9/29/09 Using ID Setting Files 7-37
To store interval spectral Ln levels,
set “Spectral Ln” to “Interval”,
enable Ln and Interval histories and
set “Intv Save Ln” to “Yes”.
Intv Enable - (LOG, SSA) Intv Enable enables or disables the automatic storage of
interval statistical records.
This setting provides the following two options:
No - Disables interval storage.
Ye s - Enables interval storage.
NOTE: If Intervals are enabled and Interval Ln’s are enabled
and Ln’s are not enabled then Ln’s are turned on and the
warning “Setting Conflict” is displayed.
Intv Period - (LOG, SSA) Intv Period sets the time interval between successive
interval storage operations. These storage operations
continue either until the instrument is stopped or runs out of
memory. You can set this to any time value in the following
range:
NOTE: If set to 00:00:00 then the period
is 0.125 seconds for SSA and infinite for
LOG.
00:00:01 to 99:59:59 (i.e. one second to 99 hours,
59 minutes and 59 seconds)
Intv Time Sync - (LOG, SSA) Intv Time Sync setting either enables or disables the time
interval sync feature. When enabled, this feature causes the
Interval history storage operations to be synchronized with
Intv Auto Stop No
Yes
Intv Threshold 0 to 255
Intv Exchange 3dB
4dB
5dB
6dB
Intv Spectrum
(SSA only)
None
@Max
Mins
To Next Page
Loading...
Need help?
General
