A-2 824 Reference Manual 9/29/09
The System 824 may be connected
to the computer directly or through a
modem. A network of many
instruments can be formed, all
controlled by one computer by using
the address-ability mode.
This chapter will describe the Serial
Port interfacing of the System 824
and the various interface commands
with their syntax. Modem control is
also covered.
Command text files and
programming examples are available
upon request via email to
techsupport@LarsonDavis.com.
Interface Cables
The communication parameters are
the following: The baud rate is
adjustable from 300 to 115200 baud,
8 data bits, parity is “None” and
stop bits are “1”. See section
Communication on page 3-34 for a
description of the communication
parameters)
Serial Port communications are
made through the 8-pin connector at
To Next Page
Loading...
