9/29/09 RTA (optional) 11-13
• Time - The 824 stops recording an Autostore after “End-
Time”.
• Count - The 824 stops recording an Autostore after “End
Samples” of data have been received.
End Level
This level is used when the “End Mode” is set to Level (L<,
L=, L>). It is the amplitude in dB at which the 824 will stop
recording an Autostore record.
• 0.0 - 255.9 dB
End Time
The 824 stops recording an Autostore record when the “End
Time” has been satisfied.
• 00.0000 to 99.9975 seconds
End Samples
The 824 stops recording an Autostore after “End Samples”
has been satisfied.
• 0 - 65535
End Logic In
When the “End Mode” is set to Input, the 824 stops
recording an Autostore record when the L logic In line
changes to “End Logic In” state.
•Low
•High
.
.
If set to 0 seconds, triggering will
repeat “forever”, and the
measurement will end when stopped
or out of memory.
If set to 0 samples, the measurement
will stop after the first event is
captured.
To Next Page
Loading...
