G-2 824 Reference Manual 9/29/09
Menu items 1 through 6 are custom IDs. Note that for ID
number 6 underscores were used as a separator to put a
break in the list between the permanent settings and the user
setting. The list is sorted by what is used most often so if a
permanent ID is used it will be seen above the line. In other
words, the IDs that are used most often float to the top of the
list and those that are not used sink to the bottom.
Hint:
To make the underscore filename easily, do the following:
1. Recall an ISM instrument (or any other ID as desired).
2. Press SETUP and highlight the top line, “Edit Settings”, and press
the TOOLS key.
3. Highlight the top line, “Save ID”, and press the check key.
4. A window pops up labeled “ID Name”.
5. Press the RESET key to clear the old name.
6. Push the right arrow key seven times to get to the last name charac-
ter.
7. Press the down arrow key about eleven times until the underscore
character is showing.
8. Press the check key.
9. Now recall all of the IDs that you want to be above the separator
line.
1) Slow-A ISM Integrating SLM set to Slow A weighted SPL
2) Fast-C ISM Integrating SLM set to Fast C weighted SPL
3) My ISM Integrating SLM with my personal preferences
4) My SSA Customized SSA with my personal settings
5) 5s_Hist SSA SSA with time histories set for 5 seconds
6) _______ ISM (dividing line setup, not used otherwise)
7) p SLM&RTA SSA
8) p SLM ISM
9) p AudTest AUD
10) p demo LOG
11) p ROOMS RTA
12) p FFT FFT
13) p Logging LOG
14) p RT60B RTA
15) p TA-LARM TAL
16) p RT60-A RTA
To Next Page
Loading...
Need help?
General
