Lenze i950

Parameterisaon sequence
As soon as the parameterisaon has been started, the following steps are iniated by the
engineering t
ool:
1.The motor rang data and the motor equivalent circuit diagram data are loaded from the
motor catalogue.
2.The motor controller sengs and the speed controller sengs are automacally calculated
based on the previously loaded data.
Notes:
•
The data involved in this parameterisaon are provided be the motor catalogue alone. Fur-
ther user data is not required.
•
The inverter characterisc is not changed by this opmisaon.
Parameter
Address Name / seng range / [default seng] Info
0x2C01:010 Motor parameters: Motor name
["MCS06C41"]
The name (e.g. " 1") can be freely selected by the user.
If the mot
or in the engineering tool has been selected from the "motor
catalog", the respecve motor name is automacally entered here
(example: "MDSKA080-22, 70").
Basic
seng
Motor data
Select motor from motor catalogue
40