Diagnostic aids 3-31
5061
Configuration Menu
The Configuration menu contains a set of menus, settings, and operations which are infrequently used by a
user. Generally, the options made available in this menu are used to configure a printer for operation.
Note: An asterisk (*) in the value list in the following menus indicates the default value.
Entering Config Menu
To enter the Configuration Menu:
1. Turn off the printer.
2. Press and hold and .
3. Turn on the printer.
4. Hold the buttons about 10 seconds (until the clock face appears).
The following are available from the Configuration Menu:
Exiting the Config Menu
Select EXIT Config Menu to exit the Configuration menu and return to normal mode.
Configuration Menu
Reset Fuser Cnt See “Reset Fuser Cnt” on page 3-32
Black Only Mode See “Black Only Mode” on page 3-32
Prt Quality Pgs See “Prt Quality Pgs” on page 3-32
Color Trapping See “Color Trapping” on page 3-32
Tray Insert Msg See “Tray Insert Msg” on page 3-32
SIZE SENSING See “SIZE SENSING” on page 3-32
Panel Menus See “Panel Menus” on page 3-33
PPDS Emulation See “PPDS Emulation” on page 3-33
Demo Mode See “Demo Mode” on page 3-33
Factory Defaults See “Factory Defaults” on page 3-33
Energy Conserve See “Energy Conserve” on page 3-33
EVENT LOG See “EVENT LOG” on page 3-33
Auto Color Adjust See “Auto Color Adjust” on page 3-34
Paper Prompts See “Paper Prompts” on page 3-34
Env Prompts See “Env Prompts” on page 3-34
Font Sharpening See “Font Sharpening” on page 3-34
Jobs On Disk See “Jobs On Disk” on page 3-35
Disk Encryption See “Disk Encryption” on page 3-35
Exit Config Menu
To Next Page
Loading...
Need help?
General
