4-32 Service Manual
5061
2. Lift the pick assembly to insert the brackets up through the appropriate openings. Once the pick assembly
brackets are through their openings, slide the assembly toward the front of the machine until the half moon
on the bracket is against the locator pin (B).
3. Reattach the spring clip to the pick arm. Make sure the pick arm rotates freely from top to bottom in the
machine.
4. Once the pick assembly is in place, put the three screws for the pick assembly back into place.
Note: Placing the front side screw in first makes it easier to put in the rest of the screws. When starting the
front screw, push the pick assembly towards the front of the printer.
5. Reconnect the connectors.
6. Reattach the paper lever sensor (three screws).
To Next Page
Loading...
