215676 300 Revision A
Figure 4.302: Deck Shift Switch
4. Select a deck position using DECK SHIFT switch (A) from one
of the following delivery options:
• B - Left-side delivery
• C - Center delivery
• D - Right-side delivery
Figure 4.303: Operator Console
5. Using HEADER DOWN switch (A) on the GSL, lower the
header fully until the lift cylinders are fully retracted.
6. Using LEFT FLOAT SWITCH (B), push + to increase the float
or – to decrease the float on the left side of the header.
Screen (D) will display the selected float value for the left
side. For example: 8.0 L FLOAT R ##.#
7. Repeat this procedure to set the float on the right side of
the header by using RIGHT switch (C). Screen (D) will
display the selected float value for both sides. For example:
8.0 L FLOAT R 3.0
Figure 4.304: Deck Shift Switch
A - Deck Shift Switch B - Left-Side Delivery
C - Center Delivery D - Right-Side Delivery
8. Select a second deck position using DECK SHIFT switch (A).
9. Repeat Step 6, page 300 and Step 7, page 300 to set the
float for the second deck position.
10. Select a third deck position with DECK SHIFT switch (A).
11. Repeat Step 6, page 300 and Step 7, page 300 to set the
float for the third deck position.
OPERATION
To Next Page
Loading...
