EasyManua.ls Logo

MacDon M155 2022 - Page 332

MacDon M155 2022
526 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
215676 312 Revision A
ü
Check walking beam width adjustment bolts
torque. For instructions, refer to 4.3.7 Adjusting
Caster Tread Width, page 174.
First 10 Hours
31
ü
Check walking beam width adjustment bolts
torque. For instructions, refer to 4.3.7 Adjusting
Caster Tread Width, page 174.
ü
Check neutral adjustment
32
.
Every 10 Hours or Daily
31
®
Clean A/C condenser
33
. For instructions, refer to
Cleaning Cooler Box Components, page 376.
®
Clean charge air cooler. For instructions, refer to
Cleaning Cooler Box Components, page 376.
ü
Check engine oil level
33
. For instructions, refer
to Checking Engine Oil Level, page 344.
ü
Check engine coolant level. For instructions,
refer to
33
Checking Coolant Level, page 368.
ü
Add fuel to fuel tank
33
. For instructions, refer to
Filling Fuel Tank, page 163.
ü
Check fuel filter water trap
33
. For instructions,
refer to Removing Water from Fuel System,
page 365.
®
Clean hydraulic oil cooler
33
. For instructions,
refer to 5.11.2 Hydraulic Oil Cooler, page 420.
ü
Check hydraulic oil level
33
. For instructions, refer
to 5.11.1 Checking and Filling Hydraulic Oil, page
419.
®
Clean radiator
33
. For instructions, refer to
Maintaining Engine Cooling Box, page 373.
ü
Check tire inflation pressure
33
. For instructions,
refer to Inflating Drive Wheel Tire, page 430.
First 50 Hours
34
ü
Inspect hose clamps: intake/radiator/heater/
hydraulic
35
. Refer to specific hose clamp section
for instructions.
ü
Check walking beam, with adjustment bolts. For
instructions, refer to 4.3.7 Adjusting Caster Tread
Width, page 174.
ü
Check caster wheel anti-shimmy dampener bolts
(if installed). For instructions, refer to Tightening
Caster Wheel Anti-Shimmy Dampeners, page
443.
MAINTENANCE AND SERVICING
31. Begins from the first use of the machine.
32. Dealer-adjusted.
33. Records of daily maintenance are not required for warranty purposes. However, these records can be maintained, if
desired.
34. Begins from first use of machine.
35. Hand-tighten these clamps unless otherwise noted.

Table of Contents

Related product manuals