FUEL SYSTEM
F–24–13
F
Caution
• Do not grasp the pipe located on the
upper surface of the set plate. The pipe
may be damaged causing fuel leakage.
19. Perform the following procedure to install the set
plate to the reserve cup.
(1) Position the fuel gauge sender unit installation
side of the reserve cup outward.
(2) Rotate the set plate 90° counter-clockwise
viewing the set plate from above.
Caution
• Be careful not to break the set plate arm
by applying excessive pressure. If it is
broken, it may cause a fuel pump unit
operation malfunction.
(3) Insert the set plate arm to the reserve cup.
(4) Engage the snap fit tab and set plate arm,
and verify that they are properly engaged.
C6E114ZL4013
SET PLATE
FUEL FILTER
(HIGH-PRESSURE)
C6E114ZL4003
SNAP FIT
TA B
SET PLATE ARM
RESERVE CUP
C6E114ZL4031
To Next Page
Loading...
