MUTOH ValueJet - Page 210

ValueJet 1304 Service manual
AP-74109 Rev 1.1 5-40
(1) A case for “Print1” or “Print2” is selected.
* The sample image is in common with Bi-D and Uni-D.
(2) A case for “Set up” (Uni-D 240) is selected.
Media set
If media is not set
Select “Print2” when adjusting Print 2
Change head gap (to Low)
Finish Printing
Back to Uni-D/Bi-D Top menu
If head gap is PG-High
Display during adjustment printing
If the temperature of the preheater and platen
heater is below 42 C
* Pressing [Cancel] key stops control and start printing
[<] key
[<] key
[>] key
[<] key
[>] key
[<] key
[>] key
[>] key
[>] key
[>] key
[>] key
[<] key
[<] key
[<] key
[<] key
[>] key
Press [Setting/Value+] or [Setting/Value-] key
to change the setting value.
1 pulse = 1/720 inch
Pulse range: -100 VQ 100