MUTOH ValueJet - Page 211

ValueJet 1304 Service manual
5-41 AP-74109 Rev 1.1
If Bi-D is selected, the parameter input process is as shown below.
(The following shows a case for “Bi-D 240 - Setup” is selected.)
NOTE
The default value is set a proper one so that genuine ink works fine.
[<] key
[<] key
[>] key
[>] key
Press [Setting/Value+] or [Setting/Value-] key
to change unit to pulseޓ
1 pulse = 1/2880 inch
Pulse range: -400 VQ400
Back to Uni㨺D/Bi-D Top menu