MUTOH ValueJet - Page 230

ValueJet 1304 Service manual
AP-74109 Rev 1.1 5-60
(The following shows a case for “Uni-D 240” is selected.)
This menu updates the printing position alignment parameters.
(The figure shown below is a case for Bi-D 240)
(4) Side Margin
This updates the side margin parameters.
[<] key
If any parameter has been changed
[<] key[>] key
[<] key[>] key
[<] key[>] key
[<] key[>] key
[<] key[>] key
[<] key[>] key
[>] key
[Enter] key
If any parameter has been changed
[Enter]
key
[Enter] key
Change the value by [setting/balue+]
or [setting/value-]key
-400 to 400
*It will be #2 when PG High
When any parameter has been changed
[Enter]
key
[Enter] key