NETGEAR M4200

MVR
302
Managed Switches
3. Add multicast group 224.1.2.3 to the MVR.
a. Select Switching > MVR > Basic > MVR Group Configuration.
A screen similar to the following displays.
b. In the MVR Group IP field, enter 224.1.2.3.
c. Click Add.
4. Configure a receiver on interface 0/1, 0/5 and 0/7.
a. Select Switching > MVR > Basic > MVR Interface Configuration.
A screen similar to the following displays.
b. Under MVR Interface Configuration, scroll down and select the Interface 0/1, 0/5 and
0/7 check boxes
c. Enter the following information:
• In the Admin Mode list, select Enable.
• In the Type list, select Receiver.
d. Click Apply to save the settings.
5. Configure a source interface.
a. Select Switching > MVR > Basic > MVR Interface Configuration.