Page | 294
The entry above will ‘remember’ the current clip with the name “AAA1”. (The
default for ID is an empty string, which is a valid storage target.)
CLIP_RESTORE
This command cues up content previously stored with a specified ID value on the
upstream source channel assigned to the network input designated.
For example:
The clip previously indexed as “AAA1” (using clip_store) is restored on the source
system output channel connected to Net 1. The playhead is set to the beginning
of the clip. (If the indexed clip is not located, nothing occurs.)
CLIP_ SELECT
Select a page (or clip) defined by the value assigned to index. This may be a number
specifying a particular page or at times, another property.
For example, sending a “clip_select” command to 3Play with a suitable numeric value
assigned as the “index” key selects a specific Play List tab by index (assuming Play List
mode is active. On the other hand, in Clip List mode, if the value for “index” was “0-
023” the clip referred to would be selected. For example:
To Next Page
Loading...
