Page | 416
For example, you may well wish to consider locking the Master audio controls to the
seventh and eighth slots, so that these important faders will always be available. To
do so, follow these steps:
1. Navigate (using NUDGE or BANK buttons if necessary) to position Master in the
furthest right control slot on Artist Mix.
2. (With FLIP and CHAN both off), press the INSERTS Knob Set button.
3. Press the small ON button located to the left of the Master 1 knob (Figure 390).
4. Press the PAN button in the Knob Set selector group (to exit INSERT mode).
A small padlock icon appears in the OLED, indicating that Master is now locked in its
current place on the control surface. If you use the navigation buttons to move left or
right, Master stays right where you want it.
Hint: When locking multiple channels on the AVID Artist Mix, always lock the rightmost of
the channels to be locked first.
Unlocking a previously locked source restores it to its normal position.
Note: Locking sources has one slightly annoying side effect. You will see a clone of locked
sources elsewhere in the Artist Mix layout. This does not pose a real issue, since the
duplicate is fully synced with the locked one, and will operate as expected if you do use it.
22.7.19 AUDIO PRESETS
Artist Mix implementation provides full access to TriCaster’s Audio Mixer preset
system. Keep in mind that these can be a very convenient way to store and recall
different source layouts for Artist Mix, too. You can choose a preset or create a new
one using either the user interface or Artist mix. To select a preset, proceed as follows:
Press Shift + INSERTS (INPUT) to display the list of existing mixer presets left to
right across the slots in the OLED display.
Press the SEL button below the PLED label of the reset you want to select.
Hint: Rotate the knob below a preset on the OLED display to access copy and paste
(preset) functions.
To Next Page
Loading...
