original is larger than the paper width of the selected roll or sheet feeder, the remaining
paper part on the right-hand side will not be scanned.
[153] Example of removing the right-hand side of an original
Copying with removed filing strip along the right-hand side
1.
Select the required media in the “Custom” section on the operator panel.
2.
Select the 100% value for the ‘Zoom’ function.
3.
Make other settings as required.
4.
Feed the original.
Leading and trailing strip
1.
It is also possible to adjust the length of both the leading and trailing strip to eliminate
or add a filing strip. Leading and trailing strips can be extended up to 400 mm or shortened
up to 100 mm.
[154] Example of adjusting the leading or trailing strip of an original
Chapter 8 - Special copy and scan jobs230
Scanning originals with filing strip
To Next Page
Loading...
