A10E/A28E/A28F Configuration Guide
Enter global configuration mode.
Alpha-A28E(config)#interface
interface-type interface-
number
Enter physical layer interface
configuration mode.
Alpha-A28E(config-
port)#upload { startup-config
| system-boot } { ftp
ip-
address user-name password
file-name
| tftp
ip-address
file-name
}
On the remote device, upload files from
the remote device to the server.
Downloading remote device files from the server to the CO device
The system bootstrap file, system startup file, configuration files, and FPGA file of the remote
device can be downloaded through FTP or TFTP from the server to the CO device, and saved
with a specified name in the flash of the remote device. This is prepared for further upgrading
of the remote device.
Download remote device files from the server to the CO device as below.
Alpha-A28E#download { remote-bootstrap |
remote-system-boot | remote-startup-config |
remote-fpga } { ftp
ip-address user-name
password file-name local-file-name
| tftp
ip-address file-name local-file-name
}
Download remote
device files from the
server to the CO
device.
Uploading remote device files from the CO device to the server
Upload remote device files from the CO device to the server as below.
Alpha-A28E#upload { remote-bootstrap |
remote-system-boot | remote-startup-config |
remote-fpga } { ftp
ip-address user-name
password file-name local-file-name
| tftp
ip-address file-name local-file-name
}
Upload remote
device files from the
CO device to the
server.
Downloading files from the CO device to the remote device
The remote device files saved in the flash of the CO device can be downloaded to the remote
device through extended OAM protocols, which can be initiated by the CO device or the
remote device. If the CO device initiates this, it can upgrade multiple remote devices.
On the CO device, download files from the CO device to the remote device as below.
To Next Page
Loading...