R&S FSW Series - Page 1143

Remote Commands
R&S
®
FSW
1143User Manual 1173.9411.02 ─ 43
TRACe<n>[:DATA] <Trace>,<Data>
TRACe<n>[:DATA]? <ResultType>
This command queries current trace data and measurement results.
The data format depends on FORMat[:DATA] on page 1142.
Suffix:
<n>
.
Window
Parameters:
<Trace> Selects the trace to write the data to.
TRACE1 | ... | TRACE6
<Data> Contains the data to transfer.
Query parameters:
<ResultType> Selects the type of result to be returned.
TRACE1 | ... | TRACE6
Returns the trace data for the corresponding trace.
For details see Table 14-7.
LIST
Returns the results of the peak list evaluation for Spurious Emis-
sion and Spectrum Emission Mask measurements.
For spurious emission measurements, the number of peaks
returned for each measurement range is defined by the "Peaks
per Range" parameter (see CALCulate<n>:PEAKsearch:
SUBRanges on page 963), regardless of the "Details" setting.
For details see Table 14-8.
SPURious
Returns the peak list of Spurious Emission measurements.
SPECtrogram | SGRam
Returns the results of the spectrogram result display.
For details see Table 14-9.
Return values:
<TraceData> For more information see tables below.
Example:
TRAC TRACE1,+A$
Transfers trace data ('+A$') to trace 1.
Example:
TRAC? TRACE3
Queries the data of trace 3.
Manual operation: See "List Evaluation State (Result Summary)" on page 266
See "List Evaluation State" on page 289
See "Diagram" on page 502
Analyzing Measurements (Basics)