R&S FSW Series - Page 1162

Remote Commands
R&S
®
FSW
1162User Manual 1173.9411.02 ─ 43
Suffix:
<n>
.
irrelevant
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
Example:
CALC:THR:STAT ON
Switches on the threshold line.
Manual operation: See "Deactivating All Search Limits" on page 216
14.8.3.4 Positioning the Marker
This chapter contains remote commands necessary to position the marker on a trace.
● Positioning Normal Markers ............................................................................... 1162
● Positioning Delta Markers................................................................................... 1165
Positioning Normal Markers
The following commands position markers on the trace.
CALCulate<n>:MARKer<m>:MAXimum:AUTO................................................................1162
CALCulate<n>:MARKer<m>:MAXimum:LEFT.................................................................1163
CALCulate<n>:MARKer<m>:MAXimum:NEXT................................................................ 1163
CALCulate<n>:MARKer<m>:MAXimum[:PEAK].............................................................. 1163
CALCulate<n>:MARKer<m>:MAXimum:RIGHt................................................................1163
CALCulate<n>:MARKer<m>:MINimum:AUTO.................................................................1164
CALCulate<n>:MARKer<m>:MINimum:LEFT.................................................................. 1164
CALCulate<n>:MARKer<m>:MINimum:NEXT................................................................. 1165
CALCulate<n>:MARKer<m>:MINimum[:PEAK]................................................................1165
CALCulate<n>:MARKer<m>:MINimum:RIGHt.................................................................1165
CALCulate<n>:MARKer<m>:MAXimum:AUTO <State>
This command turns an automatic marker peak search for a trace maximum on and
off. The R&S FSW performs the peak search after each sweep.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
Analyzing Measurements (Basics)