R&S FSW Series User Manual

Remote Commands
R&S
®
FSW
1373User Manual 1173.9411.02 ─ 43
HCOPy:ITEM:ALL
This command is maintained for compatibility reasons only. It has no effect.
SOURce<si>:EXTernal<gen>:FREQuency:SWEep[:STATe] <State>
Note that this command is maintained for compatibility reasons only. It is not required
in new remote control programs.
This command activates or deactivates the frequency sweep for the selected genera-
tor.
Suffix:
<si>
.
irrelevant
<gen>
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
Example:
SOUR:EXT:FREQ:SWE ON
Activates the frequency sweep for the external generator.
SYSTem:COMPatible <Mode>
This command enables compatibility to other spectrum and signal analyzers by R&S.
Compatibility is necessary, for example, regarding the number of sweep points.
Note that this command is maintained for compatibility reasons only. Use the
SYST:LANG command for new remote control programs (see SYSTem:LANGuage
on page 1332).
Parameters:
<Mode> DEFault | FSU | FSP | FSQ | FSV
Example:
SYST:COMP FSP
TRIGger[:SEQuence]:BBPower:HOLDoff <Period>
This command defines the holding time before the baseband power trigger event.
The command requires the optional Digital Baseband Interface or the optional Analog
Baseband Interface.
Note that this command is maintained for compatibility reasons only. Use the
TRIGger[:SEQuence]:IFPower:HOLDoff on page 1050 command for new remote
control programs.
Deprecated Commands

R&S FSW Series Specifications

General

Brand	R&S
Model	FSW Series
Category	Measuring Instruments
Language	English