R&S FSW Series User Manual

Common Measurement Settings
R&S
®
FSW
428User Manual 1173.9411.02 ─ 43
Remote command:
[SENSe:]CORRection:CVL:SELect on page 1086
Comment
An optional comment that describes the conversion loss table. The comment is user-
definable.
Remote command:
[SENSe:]CORRection:CVL:COMMent on page 1084
Band
The waveguide or user-defined band to which the table applies. This setting is checked
against the current mixer setting before the table can be assigned to the range.
For a definition of the frequency range for the pre-defined bands, see table 14-6 on
page 1079.
Remote command:
[SENSe:]CORRection:CVL:BAND on page 1083
Harmonic Order
The harmonic order of the range to which the table applies. This setting is checked
against the current mixer setting before the table can be assigned to the range.
Remote command:
[SENSe:]CORRection:CVL:HARMonic on page 1085
Bias
The bias current which is required to set the mixer to its optimum operating point. It
corresponds to the short-circuit current. The bias current can range from -10 mA to
10 mA. The actual bias current is lower because of the forward voltage of the mixer
diode(s).
Tip: You can also define the bias interactively while a preview of the trace with the
changed setting is displayed, see "Bias Value" on page 425.
Remote command:
[SENSe:]CORRection:CVL:BIAS on page 1083
Mixer Name
Specifies the name of the external mixer to which the table applies. This setting is
checked against the current mixer setting before the table can be assigned to the
range.
Remote command:
[SENSe:]CORRection:CVL:MIXer on page 1085
Mixer S/N
Specifies the serial number of the external mixer to which the table applies.
The specified number is checked against the currently connected mixer number before
the table can be assigned to the range.
Remote command:
[SENSe:]CORRection:CVL:SNUMber on page 1086
Data Input and Output

R&S FSW Series Specifications

General

Brand	R&S
Model	FSW Series
Category	Measuring Instruments
Language	English