R&S FSW Series User Manual

Common Analysis and Display Functions
R&S
®
FSW
587User Manual 1173.9411.02 ─ 43
The first group of buttons (labeled "Trace 1" to "Trace 6") selects the source trace. The
second group of buttons (labeled "Copy to Trace 1" to "Copy to Tace 6") selects the
destination.
Remote command:
TRACe<n>:COPY on page 1131
9.5.1.3 How to Configure a Standard Trace
Step-by-step instructions on configuring the trace settings are provided here.
For details on individual functions and settings see Chapter 9.5.1.2, "Trace Settings",
on page 582.
The remote commands required to perform these tasks are described in Chap-
ter 14.8.2, "Configuring the Trace Display and Retrieving Trace Data", on page 1124.
Trace settings are configured in the "Traces" dialog box.
To display the "Traces" dialog box, do one of the following:
●
Press the [TRACE] key and then select the "Trace Config" softkey.
●
Select "Analysis" from the "Overview", then select the "Traces" tab.
1. For each trace, select the "Trace Mode" and "Trace Detector". Traces with the
trace mode "Blank" are not displayed.
2. To configure several traces to predefined display modes in one step, press the but-
ton for the required function:
● "Preset All Traces"
● "Set Trace Mode Max | Avg | Min"
● "Set Trace Mode Max | ClrWrite | Min"
For details see Chapter 9.5.1.2, "Trace Settings", on page 582.
3. For "Average" trace mode, define the number of sweeps to be averaged in the
"Count:" field.
4. If linear scaling is used, select the "Average Mode": "Linear".
5. To improve the trace stability, increase the number of "Sweep Points" or the
"Sweep Time" (in the "Sweep" settings).
All configured traces (not set to "Blank") are displayed after the next sweep.
How to Copy Traces
1. A trace copy function is provided in a separate tab of the "Traces" dialog box. To
display this tab do one of the following:
● Select the [TRACE] key and then the "Trace Copy" softkey.
● Select "Analysis" from the "Overview", then select the "Trace Copy" tab.
2. Select the "Source" trace to be copied.
Trace Configuration

R&S FSW Series Specifications

General

Brand	R&S
Model	FSW Series
Category	Measuring Instruments
Language	English