R&S FSW Series - Page 721

General Instrument Setup
R&S
®
FSW
721User Manual 1173.9411.02 ─ 43
"Start / Stop Frequency"
Synchronizes the start and stop frequencies for measurements in the
frequency domain
Note: The start and stop frequencies can automatically change when
you change another frequency parameter (such as center frequency
or span).
Remote command:
INSTrument:COUPle:SPAN on page 1316
"Reference
Level"
Synchronizes the reference level
Remote command:
INSTrument:COUPle:RLEVel on page 1316
"Attenuation"
Synchronizes the attenuation
Remote command:
INSTrument:COUPle:ATTen on page 1312
"Preamplifier"
Synchronizes the gain of the optional preamplifier
Remote command:
INSTrument:COUPle:GAIN on page 1314
"Amplitude Unit"
Synchronizes the unit of the level axis
Remote command:
INSTrument:COUPle:AUNit on page 1312
"Video Bandwidth"
Synchronizes the video bandwidth
Note: You cannot synchronize the video bandwidth and the resolution
bandwidth is not possible.
Remote command:
INSTrument:COUPle:VBW on page 1317
"Resolution Bandwidth"
Synchronizes the measurement bandwidth
Note: You cannot synchronize the video bandwidth and the resolution
bandwidth simultaneously.
Remote command:
INSTrument:COUPle:BANDwidth on page 1313
"Limit Lines"
Activates the limit line over all channels
Note: Limit lines are only synchronized over channels if the limit line
is compatible to the channel configuration (especially units of the x-
and y-axis).
Remote command:
INSTrument:COUPle:LIMit on page 1314
Synchronizing Measurement Channel Configuration