R&S FSW Series - Page 922

Remote Commands
R&S
®
FSW
922User Manual 1173.9411.02 ─ 43
[SENSe:]ESPectrum<sb>:HSPeed <State>
This command turns high speed mode for SEM measurements on and off.
For more information including restrictions see Chapter 7.6.4.3, "Fast SEM Measure-
ments", on page 244.
Suffix:
<sb>
.
1 to 8
Sub block in a Multi-SEM measurement
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
Example:
ESP:HSP ON
Manual operation: See "Fast SEM" on page 252
[SENSe:]ESPectrum<sb>:RANGe<ri>:BANDwidth:RESolution <RBW>
This command defines the resolution bandwidth for a SEM range.
In case of high speed measurements, the resolution bandwidth has to be identical for
all ranges.
Suffix:
<sb>
.
1 to 8
Sub block in a Multi-SEM measurement
<ri> 1..n
Selects the measurement range.
Parameters:
<RBW> Resolution bandwidth.
Refer to the data sheet for available resolution bandwidths.
*RST: 30.0 kHz
Default unit: Hz
Manual operation: See "RBW" on page 253
[SENSe:]ESPectrum<sb>:RANGe<ri>:BANDwidth:VIDeo <VBW>
This command defines the video bandwidth for a SEM range.
In case of high speed measurements, the video bandwidth has to be identical for all
ranges.
Suffix:
<sb>
.
1 to 8
Sub block in a Multi-SEM measurement
Configuring and Performing Measurements