R&S FSW Series - Page 947

Remote Commands
R&S
®
FSW
947User Manual 1173.9411.02 ─ 43
Example:
//Select the band category 2
ESP2:MSR:BCAT BC2
//Set the base station class to medium range
ESP2:MSR:CLAS MED
//Set the maximum output power to 10 dBm.
ESP2:MSR:MPOW 10
//Set the base station RF bandwidth to 20 MHz
ESP2:MSR:RFBW 20MHZ
//LTE present
ESP2:MSR:LTE:CPR ON
//Calculate limits for MSR SEM
ESP2:MSR:APPL
Manual operation:
See "Carrier Adjacent to RF Bandwidth Edge" on page 262
[SENSe:]ESPectrum<sb>:MSR:MPOWer
<Power>
Defines the maximum output power of the base station.
This setting is only available for base stations with a medium range base station class
(see [SENSe:]ESPectrum<sb>:MSR:CLASs on page 944).
Suffix:
<sb>
.
1 to 8
Sub block in a Multi-SEM measurement
Parameters:
<Power> Range: 0 dBm to 100 dBm
Increment: 1 dB
Default unit: dBm
Example:
//Select the band category 1
ESP2:MSR:BCAT 1
//Set the base station class to medium range
ESP2:MSR:CLAS MED
//Set the maximum output power to 10 dBm.
ESP2:MSR:MPOW 10
//Set the frequency range of the base station to > 3 GHz
ESP2:MSR:BAND:HIGH
//Set the base station RF bandwidth to 20 MHz
ESP2:MSR:RFBW 20MHZ
Manual operation: See "Base Station Maximum Output Power" on page 262
[SENSe:]ESPectrum<sb>:MSR:RFBWidth <Bandwidth>
This command defines the RF bandwidth of the base station for MSR measurements.
Suffix:
<sb>
.
1 to 8
Sub block in a Multi-SEM measurement
Configuring and Performing Measurements