R&S FSW Series - Page 962

Remote Commands
R&S
®
FSW
962User Manual 1173.9411.02 ─ 43
CALCulate<n>:PEAKsearch:MARGin...............................................................................962
CALCulate<n>:PSEarch:PSHow......................................................................................963
CALCulate<n>:PEAKsearch:PSHow................................................................................963
CALCulate<n>:PSEarch:SUBRanges...............................................................................963
CALCulate<n>:PEAKsearch:SUBRanges.........................................................................963
CALCulate<n>:PSEarch:AUTO <State>
CALCulate<n>:PEAKsearch:AUTO <State>
This command turns the list evaluatio
n on and off.
Suffix:
<n>
.
Window
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Example:
CALC:PSE:AUTO OFF
Deactivates the list evaluation.
CALCulate<n>:ESPectrum:PSEarch:DETails <State>
CALCulate<n>:ESPectrum:PEAKsearch:DETails <State>
This command configures how detailed the list in the Result Summary is.
Suffix:
<n>
.
Window
Parameters:
<State> ON | OFF | 1 | 0
ON | 1
Includes all detected peaks (up to a maximum defined by
CALCulate<n>:PEAKsearch:SUBRanges on page 963).
OFF | 0
Includes only one peak per range.
*RST: 0
Example:
CALC:ESP:PSE:DET ON
CALC:PSE:SUBR 10
Includes up to 10 peaks per range in the list.
Manual operation: See "Details" on page 290
CALCulate<n>:PSEarch:MARGin <Threshold>
CALCulate<n>:PEAKsearch:MARGin <Margin>
This command defines the threshold of the list evaluation.
Suffix:
<n>
.
Window
Configuring and Performing Measurements