R&S
®
CMW 500 GPRF Applications
GPRF Command Reference
Operating Manual 1202.3986.32 – 03 185
"RUN" state.
ABORt... causes a running measurement to stop immediately; the R&S CMW
500 enters the "OFF" state.
STOP... causes a running measurement to stop after the current evaluation
period is terminated and valid results are available; the R&S CMW 500 enters the
"RDY" state.
Use FETCh...STATe? to query the current measurement state.
Example See Single Shot and Continuous Power Measurements
Characteristics Firmware version V1.00
SCPI: No query
FETCh:GPRF:MEAS<i>:POWer:STATe?
Queries the main measurement state; see Measurement Control. Use
FETCh:...:MEAS<i>:...:STATe:ALL? to query the measurement state including
the substates. Use INITiate..., STOP..., ABORt... to change the
measurement state.
Returned values:
<Main State> OFF: measurement switched off, no resources allocated, no
results available (when entered after STOP...)
RDY: measurement has been terminated, valid results may be
available
RUN: measurement running (after INITiate..., READ...),
synchronization pending or adjusted, resources activ
(see Measurement Substates)
Def. value: OFF
Example See Single Shot and Continuous Power Measurements
Characteristics Firmware version V1.00
SCPI: Query only
FETCh:GPRF:MEAS<i>:POWer:STATe:ALL?
Queries the main measurement state and the measurement substates. Both
measurement substates are relevant for running measurements only. Use
FETCh:...:MEAS<i>:...:STATe? to query the main measurement state only. Use
INITiate..., STOP..., ABORt... to change the measurement state.
Returned values:
To Next Page
Loading...
