In the information displayed by the show bfd neighbors command, the OurAddr field means the
source address of the session. The “–” is displayed if the source address is not specified, and it
occurs in the BFD session for the LSP backward IP co-operation.
#The following shows the result of the command show bfd neighbors:
Ruijie# show bfd neighbors
OurAddr NeighAddr LD/RD RH Holdown(mult) State Int
172.16.11.1 172.16.11.2 1/2 1 532 (3 ) Up Ge2/1
#The following shows the result of the command show bfd neighbors details:
Ruijie# show bfd neighbors details
OurAddr NeighAddr LD/RD RH Holdown(mult) State Int
172.16.11.1 172.16.11.2 1/2 1 532 (3 ) Up Ge2/1
Local Diag: 0, Demand mode: 0, Poll bit: 0
MinTxInt: 200000, MinRxInt: 200000, Multiplier: 5
Received MinRxInt: 50000, Received Multiplier: 3
Holdown (hits): 600(22), Hello (hits): 200(84453)
Rx Count: 49824, Rx Interval (ms) min/max/avg: 208/440/332
Tx Count: 84488, Tx Interval (ms) min/max/avg: 152/248/196 Registered
protocols: BGP
Uptime: 02:18:49
Last packet: Version: 1 - Diagnostic: 0
I Hear You bit: 1 - Demand bit: 0
Poll bit: 0 - Final bit: 0
Multiplier: 3 - Length: 24
My Discr.: 2 - Your Discr.: 1
Min tx interval: 50000 - Min rx interval: 50000
Min Echo interval: 0