Ruijie RG-S2600G-I Series User Manual

CLI Reference BFD Configuration Commands
OurAddr
Local IP address.
NeighAddr
Neighbor IP address.
LD/RD
Local & Remote identifiers.
RH/RS
Whether the remote session
responses the local session.
Holdown(mult)
Time of not receiving the hello
packets for the local session and
the times of the timeout detection.
State
The current session state.
Int
The interface number for the
session.
Session state is UP and
using echo function with 50
ms interval
Whether the session is in the echo
mode and the echo interval (which
is shown only in the echo mode).
Local Diag
Session diagnostic information.
Demand mode
Whether the session poll mode is
active or not.
Poll bit
Whether the session configuration
has been modified or not.
MinTxInt
The minimum sending interval for
the local session.
MinRxInt
The minimum receiving interval for
the local session.
Multiplier
The timeout detection times for the
local session.
Received MinRxInt
The minimum sending interval for
the remote session.
Received Multiplier
The timeout detection times for the
remote session.
Holdown (hits)
The session detection time and the
times of the timeout detection.
Hello (hits)
The minimum interval of receiving
the hello packets after the session
negotiation.
Rx Count
The number of BFD packets
received by the local session.
Rx Interval (ms)
min/max/avg
The minimum, maximum and
average intervals of receiving for
the local session.
Tx Count
The number of BFD packets sent by
the local session.
Tx Interval (ms)
min/max/avg
The minimum, maximum and
average intervals of sending for the
local session.
Registered protocols
The registered protocol type of the

Ruijie RG-S2600G-I Series Specifications

General

Brand	Ruijie
Model	RG-S2600G-I Series
Category	Switch
Language	English