Ruijie RG-S2600G-I Series - Page 1126

CLI Reference VSU Configuration Commands
Parameter
Description
Parameter
Description
N/A
N/A
Default
Configuration
The AP-based detection dual-active forwarding function is disabled by default.
Command
Mode
Interface configuration mode
Usage
Guidelines
This command can only be executed on the AP interface.
Configuration
Examples
#Enable relay function.
Ruijie(config)#interface aggregateport 1
Ruijie(config-if-AggregatePort 1)#dad relay enable
#Disable relay function.
Ruijie(config)#interface aggregateport 1
Ruijie(config-if-AggregatePort 1)#no dad relay enable
Ruijie(config-if-AggregatePort 1)#exit
Related
Commands
Command
Description
dual-active detection
Configure dual-active detection.
dual-active bfd interface
Configure BFD dual-active detection interfaces.
dual-active interface
Configure AP-based dual-active detection
interfaces
dual-active exclude interface
Configure the exclude interface of dual-active
detection.
show switch virtual dual-active
Check the configuration and status of the
dual-active detection function.
Platform
Description
N/A
port-member interface
Configure a VSL-AP member interface. The no form of this command is used to remove the member
interface.
port-member interface interface-name [ copper | fiber ]
no port-member interface interface-name