Ruijie RG-S2600G-I Series - Page 1127

CLI Reference VSU Configuration Commands
Parameter
Description
Parameter
Description
interface-name
Indicates the name of a two-dimensional interface, such as
GigabitEthernet 0/1 and GigabitEthernet 0/3.
copper
Indicates electrical port attribute.
fiber
Indicates optical port attribute.
Default
Configuration
N/A
Command
Mode
config-vsl-ap configuration mode
Usage
Guidelines
This command can be executed in both the VSU and standalone modes.
This command takes effect only after you save the command configuration and reload the device
where the VSL member ports are.
Configuration
Examples
#Add/remove a VSL-AP member port in the standalone mode.
Ruijie(config)# vsl-aggregateport 1
Ruijie(config-vsl-ap-1)# port-member interface GigabitEthernet 0/1
Ruijie(config-vsl-ap-1)# no port-member interface GigabitEthernet 0/2
#Add/remove a VSL-AP member port in the VSU mode.
Ruijie(config)# vsl-aggregateport 1/1
Ruijie(config-vsl-ap-1/1)# port-member interface GigabitEthernet 0/1
Ruijie(config-vsl-ap-1/1)# no port-member interface GigabitEthernet 0/1
Related
Commands
Command
Description
vsl-aggregateport
Enter the vsl-ap configuration mode.
Platform
Description
N/A
remove configuration switch
Remove the configuration of a specific device and automatically restart the device.
remove configuration switch sw_id
Parameter
Description
Parameter
Description
sw_id
Indicates the ID of a switch in VSU. The value range is 1 to 8.
Default
N/A