Ruijie RG-S2600G-I Series - Page 266

CLI ReferenceInterface Configuration Commands MSTP Configuration Commands
Platform Description
-
spanning-tree guard none
This command is used to disable the guard on an interface. You can use the no option of this
command to disable the guard on the interface.
spanning-tree guard none
no spanning-tree guard none
Parameter
Description
Parameter
Description
-
-
Defaults
Disabled
Command Mode
Interface configuration mode
Usage Guide
-
Configuration
Examples
Ruijie(config)# spanning-tree guard none
Related Commands
Command
Description
-
-
Platform Description
-
spanning-tree guard root
This command is used to enable the root guard on an interface to prevent the change of
current root bridge position because of error configuration and illegal message attacks. You
can use the no option of this command to disable the root guard on the interface.
spanning-tree guard root
no spanning-tree guard root
Parameter
Description
Parameter
Description
-
-
Defaults
Disabled
Command Mode
Interface configuration mode