CLI ReferenceInterface Configuration Commands MSTP Configuration Commands
Ruijie(config)# spanning-tree guard root
spanning-tree ignore tc
This command is used to enable the tc filtering switch on an interface. You can use the no
option of this command to disable the tc filtering switch on the interface. With tc filtering enabled,
the TC messages received on the interface will not be processed.
spanning-tree ignore tc
no spanning-tree ignore tc
By default, the TC filtering function is disabled.
Interface configuration mode
Ruijie(config-if)# spanning-tree ignore tc
spanning-tree link-type
This command is used to configure the link type of the interface to ―point to point‖. You can use
the no option of the command to restore the default configuration.
spanning-tree link-type [ point-to-point | shared ]
no spanning-tree link-type
To Next Page
Loading...
Need help?
General