CLI Reference IPv6 Configuration Commands
outgoing interface must be specified; if the destination address is a link-local IP address, the
next-hop must be also a link-local IP address. When configuring a route, the destination IP
address and the next-hop IP address shall not be a multicast address. If both the next hop IP
address and the outgoing interface are specified, the outgoing interface of the direct route that
matches the next hop shall be the same as the configured outgoing interface.
Ruijie(config)# ipv6 route 2001::/64 vlan 1 2005::1
Show the IPv6 route information.
Use this command to forward the IPv6 packet with route header. The no form of this command
disables the forwarding.
Global configuration mode.
Because of the potential security of the header of type 0 route, it‟s easy for the device to suffer from
the denial service attack. Therefore, forwarding the IPv6 packet with route header is disabled by
default. However, the IPv6 packet of route header with type 0 that destined to the local machine is
processed.
Ruijie(config)# no ipv6 source-route
To Next Page
Loading...
Need help?
General