CLI Reference IPv4 REF Configuration Commands
IPv4 REF Monitoring and Maintenance Command
show ip ref
This command is used to display current global statistics of REF, including current routing
number, adjacent node number, load balancing table number and weight node number.
This command is as follows:
show ip ref
This command can be used to display current packet statistics of REF.
Ruijie# show ip ref
-----------statistic information-----------:
current routes: 5
alloc weight_nodes: 5
alloc bal_tables: 0
alloc adj_nodes: 5
alloc res_adj: 0
Number of routes in the REF table
Number of the weight nodes.
Number of the load balancing tables
Number of the adjacent nodes.
Number of the registered resolution nodes.
To Next Page
Loading...
Need help?
General