Ruijie RG-S2600G-I Series User Manual

CLI Reference IGMP Snooping Configuration Commands
needing to send packets, the device will verify
whether the source IP address is specified globally.
The device can only send query packets after finding
the source IP configured, or else the querier function
won't take effect.
If the IGMP querier source IP has been specified in
VLAN, the source IP configured in the relevant
VLAN will be used first.
Examples
The following example specifies the source IP of
query packets on the device:
Ruijie(config)# ip igmp snooping querier address
1.1.1.1
Related
commands
Command
Description
ip igmp snooping vlan
querier address
Enable the source IP
check in VLAN
Platform
description
Supported after release 10.4(3).
ip igmp snooping querier max-response-time
To configure the maximum response time advertised in query packets, execute the global
configuration command of "ip igmp snooping querier max-response-time". Use no form of
this command to restore to the default value.
ip igmp snooping querier max-response-time num
no ip igmp snooping querier max-response-time
Parameter
description
Parameter
Description
num
Maximum response
time (1-25); unit:
second; default: 10
Default
By default, the maximum response time is 10
seconds.
Command
mode
Global configuration mode.
Usage
guidelines
Configure this command to specify the maximum
response time to query packets.
By default, the maximum response time is 10

Ruijie RG-S2600G-I Series Specifications

General

Brand	Ruijie
Model	RG-S2600G-I Series
Category	Switch
Language	English